The bar chart already includes a comparison to a Hitachi Deskstar 7K1000.C 1TB hard drive and some Crucial, OCZ, Mach Extreme and ADATA SSDs, where the Seagate is in both transfer sizes well below most other SSDs. The ATTO disk benchmark values are compared with a small transfer size of 32KB and a large transfer size of 8192KB. Here is a Snipping screenshot of the ATTO Disk benchmark values (SATA3 AHCI): Here is a Snipping screenshot of the ATTO Disk benchmark values (SATA3 IDE): Here you can see the very constant read and write speeds with approximately 168 MB/s at a small size of about 16 KB and only slightly differences in AHCI mode. The ATTO disk benchmark values gives a very good overview about the write and read rate on different file sizes. However, ASSSD is not intended for platter hard drives, so we have skipped this test. The SSHD benchmark values offers a very good reference point of the maximal possible reading and writing performance, the speed with smaller files and the respective access time. The SSHD drive speed was examined and compared with the following benchmark software: At present, Microsoft Windows 7 Ultimate Edition is used as the operating system. SATA3 drives are currently tested with an ASRock 890GX Extreme3 motherboard. The app works fine on all versions of Windows including Windows XP, 7 and 8.Let us continue with the benchmark results. It is a free, light-weight application that can be downloaded free of cost by searching on Google. The app does not recommend solutions to improving the read and write speed of your hard drives. Hence you have to analyze the data yourself and improve wherever need on your own. When the program is finished after conducting the tests, you are presented with nice statistics including the following:ĭiskMark is a free, yet simple application that does what it is supposed to do. You can also check Allow immediate caching? To start caching the drive when the write and read speed is analyzed. Leave other files such as Set size, Rounds and Runs as is. Since I have three partitions on my hard disk, I would go for the C: drive. When you launch the program, a small pop up asks you for the confirmation of hard drive to be selected for benchmarking. On the left side, there is a table that displays the results of speeds. Upon the first launch of this program, there are two empty areas of graphs for which you can easily monitor the read and write speed. To me, there was not a single issue in running the program and measuring the results. The program works fine on Windows 7 and 8, however I tested it on a windows 8 machine that is 64-bit powered. It measures the performance and displays the read/write speed, total cache size, and other important information pertaining to your hard/solid state drives. While there are expensive applications that can do this for you, there are tons of free apps out there as well that can measure read/write speed and benchmark your drive’s performance without costing you a single cent.ĭiskMark is an excellent, feature-rich, and simple program that does all of these tasks for you. Whether you have bought a new disk or just wondering about measuring the performance, it is always a good idea of see where your hardware is currently positioned by having it benchmarked. ![]() It is a free application that allows you to benchmark the performance of your hard drives and solid state drives. ![]() We shall do another review of yet a cool new application named DiskMark. We have reviewed quite a few HDD and SSD monitoring programs through which you can monitor the speed of data transfer and perform other important disk management tasks. For full review on what it does, read the article. We have reviewed SSD/HDD benchmarking utlity named DiskMark.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |